Image is for your reference only,please check specifications for details
Updated at 17/06/2025 10:30:15(UTC+8)
Certifications
ManyChip is committed to product quality and safety with ISO 9001, ISO 13485, ISO 45001, UL, RoHS, CQC and REACH certifications.
Description
- Overview
- The PCA9745B is a daisy-chain SPI-compatible 4-wire serial bus controlled 16-channel constant current LED driver optimized for dimming and blinking 57 mA Red/Green/Blue/Amber (RGBA) LEDs in amusement products. Each LED output has its own 8-bit resolution (256 steps) fixed frequency individual PWM controller that operates at 31.25 kHz with a duty cycle that is adjustable from 0 % to 100 % to allow the LED to be set to a specific brightness value. An additional 8-bit resolution (256 steps) group PWM controller has both a fixed frequency of 122 Hz and an adjustable frequency between 15 Hz to once every 16.8 seconds with a duty cycle that is adjustable from 0 % to 99.6 % that is used to either dim or blink all LEDs with the same value.
- Each LED output can be off, on (no PWM control), set at its individual PWM controller value or at both individual and group PWM controller values. The PCA9745B operates with a supply voltage range of 3 V to 5.5 V and the constant current sink LED outputs allow up to 20 V for the LED supply. The output peak current is adjustable with an 8-bit linear DAC from 225 μA to 57 mA.
- Gradation control for all current sources is achieved via the 4-wire serial bus interface and allows user to ramp current automatically without MCU intervention. 8-bit DACs are available to adjust brightness levels for each LED current source. There are four selectable gradation control groups and each group has independently four registers to control ramp-up and ramp-down rate, step time, hold ON/OFF time and final hold ON output current. Two gradation operation modes are available for each group, one is single shot mode (output pattern once) and the other is continuous mode (output pattern repeat). Each channel can be set to either gradation mode or normal mode and assigned to any one of these four gradation control groups.
- This device has built-in open, short load and overtemperature detection circuitry. The error information from the corresponding register can be read via the 4-wire serial bus. Additionally, a thermal shutdown feature protects the device when internal junction temperature exceeds the limit allowed for the process.
- The PCA9745B device is designed to use 4-wire read/write serial bus with higher data clock frequency (up to 25 MHz).
- The active LOW output enable input pin (OE) blinks all the LED outputs and can be used to externally PWM the outputs, which is useful when multiple devices need to be dimmed or blinked together without using software control.
- MoreLess
- ## Features
- * 16 LED drivers. Each output programmable at:
- * Off
- * On
- * Programmable LED brightness
- * Programmable group dimming/blinking mixed with individual LED brightness
- * Programmable LED output delay to reduce EMI and surge currents
- * Gradation control for all channels
- * Each channel can assign to one of four gradation control groups
- * Programmable gradation time and rate for ramp-up and/or ramp-down operations
- * Programmable step time (6-bit) from 0.5 ms (minimum) to 512 ms (maximum)
- * Programmable hold-on time after ramp-up and hold-off time after ramp-down (3-bit) from 0 s to 6 s
- * Programmable final ramp-up and hold-on current
- * Programmable brightness current output adjustment, either linear or exponential curve
- * 16 constant current output channels can sink up to 57 mA, tolerate up to 20 V when OFF
- * Output current adjusted through an external resistor (REXT input)
- * Output current accuracy
- * ±4 % between output channels
- * ±6 % between PCA9745B devices
- * Open/short load/overtemperature detection mode to detect individual LED errors
- * 4-wire serial bus interface with 25 MHz data clock rate
- * 256-step (8-bit) linear programmable brightness per LED output varying from fully off (default) to maximum brightness fully ON using a 31.25 kHz PWM signal
- * 256-step group brightness control allows general dimming (using a 122 Hz PWM signal) from fully off to maximum brightness (default)
- * 256-step group blinking with frequency programmable from 15 Hz to 16.8 s and duty cycle from 0 % to 99.6 %
- * Active LOW Output Enable (OE) input pin allows for hardware blinking and dimming of the LEDs
- * 8 MHz internal oscillator requires no external components
- * Internal power-on reset
- * Noise filter on SDI/SCLK inputs
- * No glitch on LEDn outputs on power-up
- * Low standby current
- * Operating power supply voltage (VDD) range of 3 V to 5.5 V
- * 5.5 V tolerant inputs on non-LED pins
- * ˗40 ºC to +105 ºC operation
- * ESD protection exceeds 4 kV HBM per JESD22-A114
- * Latch-up testing is done to JEDEC Standard JESD78 which exceeds 100 mA
- * Packages offered: HTSSOP28
- ## Features
- * Packages offered: HTSSOP28
PCA9745BTWJ Specifications
| Attribute | Attribute Value |
|---|---|
| Datasheet | Datasheet |
| 3D Model | 3D Model |
| Mounting Style | Surface Mount |
| Number of Pins | 28 Pin |
| Case/Package | HTSSOP-28 |
| Frequency | 8 MHz |
| Number of Outputs | 16 Output |
| Output Voltage | 20 V |
| Number of Channels | 16 Channel |
| Number of Positions | 28 Position |
| Power Dissipation | 2560 mW |
| Switching Frequency | 31.25 kHz |
| Input Voltage (Max) | 5.5 V |
| Input Voltage (Min) | 3 V |
| Input Voltage (DC Max) | 5.5 V |
| Input Voltage (DC Min) | 3 v |
| Output Voltage (Max) | 20 V |
| Output Current (Max) | 57 mA |
| Operating Temperature (Max) | 105 ℃ |
| Operating Temperature (Min) | -40 ℃ |
| Power Dissipation (Max) | 2560 mW |
| Show | |
| Operating Temperature | -40℃ ~ 105℃ |
| Product Lifecycle Status | Unknown |
| Packaging | Tape & Reel (TR) |
| RoHS | RoHS Compliant |
| Lead-Free Status | Lead Free |
Order guide
-
TT in advance (bank transfer), Western Union, Credit card,
PayPal. Customer is responsible for shipping fee, bank
charges, duties and taxes.
-
- You can choose whether shipping charges will be charged through your shipping account or by us.
- Please confirm with the logistics company in advance for remote areas.
(Additional charges ($35-$50) may apply for delivery in these areas)
- Delivery date: usually 2 to 7 working days.
- A tracking number will be sent after your order ships.
- - Carefully inspected and packed by ManyChip warehouse - Vacuum packaging - Anti-static packaging - Shockproof foam
- The terms here are for reference only, the actual terms are subject to the sales quotation. - Please confirm product specifications when ordering. - MOQ refers to the minimum order quantity required to purchase each part. - If you have special ordering instructions, please indicate them on the ordering page. - Inspection (PSI) will be performed prior to shipment.
- - Income Quality Control (IQC), 1000+ qualified dealers. - Chips are tested by authoritative organizations to ensure the quality, authenticity and safety of your device. - Decapsulation control - X-ray control - XRF inspection - Electrical testing - Surface testing -Digital components warehouse, covering an area of 800 square meters, with constant temperature and humidity
Contact Us
If you have any problem,please email to sales@manychip.com, we will response as soon as possisble.
Popular Search Parts
- Recommended Parts
- Hot Parts
- Popular Parts
- Recently Popular Parts
- PTN5150AHXMP NRVTSA4100ET3G SN74LV1T34DCKR LM5143QRWGRQ1 DLW21SN900SQ2 TLV3201AIDCKR PTN5150HXMP BLM18HE152SN1 DP83867ISRGZT TPS1H200AQDGNRQ1
- TPS1H200AQDGNRQ1 TPS62745DSST ADS8422IBPFBT TL7700CPS TPS3808G01MDBVTEP SN74LVC1G14QDCKRQ1 LMR16030SDDA SBAT54ALT1G SZMMSZ4684T1G PCAL6524HEAZ
- UCC3895DW LNK302DN 1N4732A OPA2277UA AD592 OPA2134UA 1N5818 74HC165D OP777 AO4435
- MFMCA0050EED BTS70021EPPXUMA1 2903332 1212365 2811394 1715000 1619415 TLE94106ES SN74LS38N KSZ9563RNXI
SN:H1.02573LO97737V29Q0QC0S1
Buy PCA9745BTWJ
Please fill the information below to send RFQ quickly,and we will respond immediately.